ADVERTISEMENT
NTSB issues urgent safety recommendations on Boeing 737 rudder after Newark incidentThe Federal Aviation Administration said it has been monitoring this situation closely and on Friday 'will convene a corrective action review board based upon the NTSB’s interim recommendations and determine next steps'.
Reuters
Last Updated IST
<div class="paragraphs"><p>A Boeing 737.</p></div>

A Boeing 737.

Credit: Reuters Photo

Washington: The National Transportation Safety Board on Thursday issued urgent safety recommendations about the potential for a jammed rudder control system on some Boeing 737 airplanes after a February incident involving a United Airlines flight.

ADVERTISEMENT

The NTSB is investigating an incident in which the rudder pedals on a United Boeing 737 MAX 8 were "stuck" in the neutral position during a landing at Newark. There were no injuries to the 161 passengers and crew.

United said the rudder control parts at issue were in use in only nine of its 737 aircraft originally built for other airlines. United said on Thursday the components were all removed earlier this year.

The Federal Aviation Administration said it has been monitoring this situation closely and on Friday "will convene a corrective action review board based upon the NTSB’s interim recommendations and determine next steps."

The FAA said United Airlines was the only US operator that had the components in use and said it believed they were no longer in service.

The NTSB on Thursday recommended Boeing notify flight crews the rudder control system can jam due to moisture that has accumulated inside the actuators and frozen and that Boeing "determine appropriate flight crew responses besides applying maximum pedal force" for such situations in flight or during landing.

It also recommended the FAA determine if some actuators produced by Collins Aerospace, a unit of RTX, should be removed from airplanes and to halt use of the planes until replacement units are installed. It also wants the FAA to notify international aviation regulators if they decide the components should be removed.

Collins Aerospace determined a bearing was incorrectly assembled during production of the actuators and said more than 353 actuators delivered since February 2017 to Boeing were affected by this condition, the NTSB said.

Boeing did not immediately comment. RTX did not immediately respond to a request for comment.

ADVERTISEMENT
(Published 27 September 2024, 07:10 IST)